Where can I find Replacement O-Rings for my Bomb 3-Way?
   Replacement O-Rings for the Bomb 3-Way are available by calling 708.862.7446

    Why do my front hoses keep blowing off?
    A. Your fgp regulator is turned up to high. When the regulator is set properly you should be able to push the back block
         forward with some resistance while holding the trigger back.
    B. Shrader pin is leaking, call 708.418.8890 ext. 14 and ask for a replacement.

   Which bolt will fit my Autococker?
   A. 99 Bolt- For all full size guns with full size blocks made before 2000.
   B. STO- Bolt for all mass produced P-blocked guns including all Evolutions and pre 2000 STO Autocockers.
   C. 2000 Bolt- For all markers made in 2000 and after which use the new style back block.

   What should the input pressure be going into my Shocktech Autococker?
   The input pressure from the regulator should be between 250-350psi. To set the regulator properly screw the IVG in until
   you can see four threads. Then adjust the regulator until the gun is cycling properly. Use the IVG to adjust your fps.

   Do the Delrin bolts need to be oiled?
   The Delrin bolts are self-lubricating and do not need to be oiled.

   What should I use to lubricate the Bomb 3-Way O-Rings?
   Shocktech recommends using vaseline to lube these O-Rings.

   How much does it cost to have my Autococker tuned and timed?
   Shocktech charges $29.99 to tune and time an Autococker.